Compatibility · Oct 2026

Nagaoka MP-150 on the Pro-Ject T2 W: does it fit?

Checked on paper: the tonearm of the Pro-Ject T2 W (Pro-Ject 9 aluminium, 9.5 g effective mass) with the cartridge Nagaoka MP-150 (6.5 g). The Advisor arrives at 11.7 Hz (range 10.6–12.9 Hz); the verdict is “fits”. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: fits Resonance 11.7 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: fits

Fits according to our calculation. All three checks (mounting, resonance, counterweight) pass.

  • Resonance: 11.7 Hz (range 10.6–12.9 Hz)
  • Moving mass: 17 g
  • Compliance: 10.8 µm/mN at 10 Hz
  • Cartridge: 6.5 g

The Nagaoka MP-150 is a stiff cartridge (6×10⁻⁶ cm/dyn at 100 Hz) and reaches about 11.7 Hz on the T2 W. The upper end of the range, 12.9 Hz, is above the target zone but below the warning limit of 14 Hz; because the middle stays in the target zone the result is “fits”. Price-wise the MP-150 is at about €320 to 380 according to our test page, well above the factory Rainier (about €140 to 170).

Resonance band: Nagaoka MP-150 on Pro-Ject T2 W Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 11.7 Hz, range 10.6 to 12.9 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 11.7 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

The check runs in three steps: does the cartridge physically fit the arm, does the resonance of arm and cartridge lie in the target zone, and can the counterweight balance the cartridge weight? The weakest point decides the overall verdict.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonancefits

    The calculated resonance of 11.7 Hz lies in the target zone. The rule-of-thumb range stays within the warning limits.

    Advisor output: fᵣ ≈ 11.7 Hz (range 10.6–12.9 Hz) by 159 / √(17 × 10.8); target 8–12 Hz, warning outside 7–14 Hz. Mass 9.5 g arm + 6.5 g cartridge + 1 g screws = 17 g; compliance 6 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 9–13.2 µm/mN at 10 Hz (rule of thumb, middle 10.8). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–11.5 g.

    Advisor output: Cartridge 6.5 g is within the range 5–11.5 g (cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)).

How the resonance comes about

  1. Moving mass: 9.5 g arm + 6.5 g cartridge + 1 g screws = 17 g.
  2. Compliance at 10 Hz: The compliance of 6×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 9 to 13.2 µm/mN; the calculation uses the middle (factor 1.8): 10.8 µm/mN.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(17 × 10.8) = 159 / √183.6 ≈ 11.7 Hz.
  4. Range: Because the compliance is converted, the result is 10.6–12.9 Hz (worst and best case).

The input data

Tonearm: Pro-Ject 9 aluminium (Pro-Ject T2 W)

Effective mass
9.5 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
5–11.5 g · cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)

Cartridge: Nagaoka MP-150

Type
MP high-output · Nude Elliptical 0.4×0.7 mil
Weight
6.5 g
Compliance
6×10⁻⁶ cm/dyn at 100 Hz
Tracking force
15–20 mN · recommended 18 mN (1.8 g)
Output voltage
4.5 mV
Market price
about €320–380 (prices without guarantee, Oct 2026)

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

What you can do with this

  • Set the tracking force as specified by the manufacturer (15–20 mN · recommended 18 mN (1.8 g)) and check it with a gauge.
  • Set the overhang with the alignment protractor, then the anti-skating.
  • Compare the manufacturer’s specifications for arm and cartridge before you order or mount.

The Nagaoka MP-150 is a moving-magnet cartridge (4.5 mV) and works on a normal MM phono input. If the Pro-Ject T2 W has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: From another manufacturer: the Sumiko Moonstone (about €300–390) weighs 6.6 g and calculates to 8.3 Hz, lower in the target zone.

More cartridges on the Pro-Ject T2 W

For comparison: on the Pro-Ject T2 W these cartridges are also an option according to the calculation, at a similar price (without guarantee):

The Nagaoka MP-150 on other turntables

On paper the Nagaoka MP-150 can also be run on these turntables without objection:

Method in brief

Procedure
Same formula as in the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Is the Nagaoka MP-150 a good choice for the Pro-Ject T2 W?

Yes, according to our calculation the Nagaoka MP-150 fits the Pro-Ject T2 W: mounting, resonance and counterweight pass. Calculated resonance: 11.7 Hz (range 10.6–12.9 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

At what frequency do the Nagaoka MP-150 and the arm of the Pro-Ject T2 W resonate?

About 11.7 Hz (range 10.6–12.9 Hz). The calculation uses 159 / √(mass × compliance): 17 g moving mass (arm 9.5 g, cartridge 6.5 g, screws 1 g) and 10.8 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject T2 W sufficient for the Nagaoka MP-150?

The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–11.5 g.

What is fitted to the Pro-Ject T2 W at the factory?

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026