Compatibility · Oct 2026

Ortofon 2M Blue on the Thorens TD 403 DD: does it fit?

Checked on paper: the tonearm of the Thorens TD 403 DD (Thorens TP 150, 14.5 g effective mass) with the cartridge Ortofon 2M Blue (7.2 g). The Advisor arrives at 7.5 Hz (range 7.4–7.5 Hz); the verdict is “borderline”. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: borderline Resonance 7.5 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: borderline

Borderline: at least one point is at the edge. Checks at the edge: Resonance; open: Counterweight.

  • Resonance: 7.5 Hz (range 7.4–7.5 Hz)
  • Moving mass: 22.7 g
  • Compliance: 20 µm/mN at 10 Hz
  • Cartridge: 7.2 g

The TD 403 DD ships with the 2M Blue, so the calculation describes the as-delivered state. According to the manufacturer the effective mass of the TP 150 is about 14 g; we calculate with 14.5 g (14 to 15 g). The 2M Blue is suspended softly (20 µm/mN): the resonance is about 7.5 Hz, below the target zone but above the warning limit. No weight range is documented for the counterweight, so this point stays open.

Resonance band: Ortofon 2M Blue on Thorens TD 403 DD Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 7.5 Hz, range 7.4 to 7.5 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 7.5 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

The check runs in three steps: does the cartridge physically fit the arm, does the resonance of arm and cartridge lie in the target zone, and can the counterweight balance the cartridge weight? The weakest point decides the overall verdict.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Removable headshell; half-inch standard (assumption for standard cartridges, source Wikipedia “Tonearm”).

  • Resonanceborderline

    The resonance of 7.5 Hz is below the target zone. Low resonances react more strongly to warped records and footfall; below 7 Hz this counts as a warning, not as an exclusion.

    Advisor output: fᵣ ≈ 7.5 Hz (range 7.4–7.5 Hz) by 159 / √(22.7 × 20); target 8–12 Hz, warning outside 7–14 Hz. Mass 14.5 (14–15) g arm + 7.2 g cartridge + 1 g screws = 22.7 g; compliance 20 µm/mN (10 Hz, per data sheet). Calculation note, not a measurement.

  • Counterweightnot verifiable

    No weight range is documented for this arm’s counterweight; the cartridge weighs 7.2 g.

    Advisor output: Weight range of the arm not documented (n/a) – check the manufacturer’s specification (cartridge 7.2 g).

How the resonance comes about

  1. Moving mass: 14.5 g arm (range 14–15 g) + 7.2 g cartridge + 1 g screws = 22.7 g.
  2. Compliance at 10 Hz: The compliance of 20 µm/mN is specified at 10 Hz and is used unchanged.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(22.7 × 20) = 159 / √454 ≈ 7.5 Hz.
  4. Range: Because the arm mass is given as a range, the result is 7.4–7.5 Hz (worst and best case).

The input data

Tonearm: Thorens TP 150 (Thorens TD 403 DD)

Effective mass
14.5 g (range 14–15 g) · manufacturer figure, source: thorens.com
Mounting
removable headshell
Counterweight
not documented

Cartridge: Ortofon 2M Blue

Type
MM · Nude Elliptical r/R 8/18 µm
Weight
7.2 g
Compliance
20 µm/mN at 10 Hz
Tracking force
1.6–2.0 g · recommended 1.8 g
Output voltage
5.5 mV
Market price
about €160–200 (prices without guarantee, Oct 2026)

The Thorens TD 403 DD ships with exactly this cartridge (Ortofon 2M Blue). The calculation therefore describes the as-delivered state.

What you can do with this

  • Check the highlighted points above (Resonance) in the manufacturer’s documents.
  • If needed, ask a dealer or the manufacturer whether the combination is recommended in everyday use.
  • If you are unsure, look for a cartridge that passes all three checks (see the alternatives below).

The Ortofon 2M Blue is a moving-magnet cartridge (5.5 mV) and works on a normal MM phono input. If the Thorens TD 403 DD has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: On the Technics SL-1200GR2 the 2M Blue reaches 8.7 Hz with 8.5 g of arm mass and a documented counterweight range.

The Ortofon 2M Blue on other turntables

On paper the Ortofon 2M Blue can also be run on these turntables without objection:

Method in brief

Procedure
Same formula as in the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Is the Ortofon 2M Blue a good choice for the Thorens TD 403 DD?

With reservations. The Ortofon 2M Blue on the Thorens TD 403 DD is borderline; Resonance is at the edge of the target zone. Calculated resonance: 7.5 Hz (range 7.4–7.5 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

At what frequency do the Ortofon 2M Blue and the arm of the Thorens TD 403 DD resonate?

About 7.5 Hz (range 7.4–7.5 Hz). The calculation uses 159 / √(mass × compliance): 22.7 g moving mass (arm 14.5 g, cartridge 7.2 g, screws 1 g) and 20 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Thorens TD 403 DD sufficient for the Ortofon 2M Blue?

No weight range is documented for this arm’s counterweight; the cartridge weighs 7.2 g. Check the manufacturer’s specification before buying.

What is fitted to the Thorens TD 403 DD at the factory?

The Thorens TD 403 DD ships with exactly this cartridge (Ortofon 2M Blue). The calculation therefore describes the as-delivered state.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet. Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026