Compatibility · Oct 2026

Audio-Technica AT-VM95ML on the Pro-Ject X2 B: does it fit?

Does the Audio-Technica AT-VM95ML fit the tonearm of the Pro-Ject X2 B? With 13.5 g of effective arm mass and 6.1 g for the cartridge the calculation gives 8.3 Hz (range 7.5–9 Hz); verdict: does not fit. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: does not fit Resonance 8.3 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: does not fit

Does not fit: one point is clearly outside. Checks outside: Counterweight.

  • Resonance: 8.3 Hz (range 7.5–9 Hz)
  • Moving mass: 20.6 g
  • Compliance: 18 µm/mN at 10 Hz
  • Cartridge: 6.1 g

The X2 B has a heavy arm (13.5 g) and a counterweight (No. 31) that only starts at 7 g. The AT-VM95ML weighs 6.1 g and is 0.9 g below that. The resonance alone, at about 8.3 Hz, would be fine. Pro-Ject ships the X2 B with the Ortofon Quintet Red (MC); such a light MM cartridge cannot be balanced cleanly with the supplied weight. The calculation reports “does not fit”.

Resonance band: Audio-Technica AT-VM95ML on Pro-Ject X2 B Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 8.3 Hz, range 7.5 to 9 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 8.3 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

Whether arm and cartridge work together depends on mounting, resonance and counterweight. Each point is rated on its own, and the verdict follows the worst result.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonancefits

    The calculated resonance of 8.3 Hz lies in the target zone. The rule-of-thumb range stays within the warning limits.

    Advisor output: fᵣ ≈ 8.3 Hz (range 7.5–9 Hz) by 159 / √(20.6 × 18); target 8–12 Hz, warning outside 7–14 Hz. Mass 13.5 g arm + 6.1 g cartridge + 1 g screws = 20.6 g; compliance 10 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 15–22 µm/mN at 10 Hz (rule of thumb, middle 18). Calculation note, not a measurement.

  • Counterweightdoes not fit

    The cartridge (6.1 g) is lighter than the lower limit of 7 g. The arm cannot be balanced cleanly with it.

    Advisor output: Cartridge 6.1 g outside the range 7–12 g (cartridge weight (Pro-Ject: counterweight No. 31 for 7–12 g)).

How the resonance comes about

  1. Moving mass: 13.5 g arm + 6.1 g cartridge + 1 g screws = 20.6 g.
  2. Compliance at 10 Hz: The compliance of 10×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 15 to 22 µm/mN; the calculation uses the middle (factor 1.8): 18 µm/mN.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(20.6 × 18) = 159 / √370.8 ≈ 8.3 Hz.
  4. Range: Because the compliance is converted, the result is 7.5–9 Hz (worst and best case).

The input data

Tonearm: Pro-Ject 9 carbon/alu sandwich (Pro-Ject X2 B)

Effective mass
13.5 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
7–12 g · cartridge weight (Pro-Ject: counterweight No. 31 for 7–12 g)

Cartridge: Audio-Technica AT-VM95ML

Type
VM Dual-MM · Nude MicroLine 2.2×0.12 mil
Weight
6.1 g
Compliance
10×10⁻⁶ cm/dyn at 100 Hz
Tracking force
1.8–2.2 g · recommended 2.0 g
Output voltage
3.5 mV
Market price
about €150–190 (prices without guarantee, Oct 2026)

According to the manufacturer the Pro-Ject X2 B ships with a different cartridge (Ortofon Quintet Red (MC)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

Next steps

  • Based on the calculation we advise against this combination; decisive: Counterweight.
  • Choose a cartridge within the arm’s weight range (see the alternatives below).
  • Check the manufacturer’s specification if you suspect an exception; the calculation is no substitute for the manufacturer’s approval.

The Audio-Technica AT-VM95ML is a moving-magnet cartridge (3.5 mV) and works on a normal MM phono input. If the Pro-Ject X2 B has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: Inside the arm’s weight range lies the MC cartridge Ortofon Quintet Blue (about €480–550): 9 g and 8.5 Hz.

More cartridges on the Pro-Ject X2 B

Also unproblematic on paper on the Pro-Ject X2 B are these cartridges in a comparable price range (without guarantee):

The Audio-Technica AT-VM95ML on other turntables

If you would rather change the turntable: on these models the Audio-Technica AT-VM95ML passes all three checks:

Method in brief

Procedure
Following the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Can I run the Audio-Technica AT-VM95ML on the Pro-Ject X2 B?

Not according to our calculation. The Audio-Technica AT-VM95ML on the Pro-Ject X2 B fails on Counterweight. Calculated resonance: 8.3 Hz (range 7.5–9 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

What resonance frequency results for the Audio-Technica AT-VM95ML on the Pro-Ject X2 B?

About 8.3 Hz (range 7.5–9 Hz). The calculation uses 159 / √(mass × compliance): 20.6 g moving mass (arm 13.5 g, cartridge 6.1 g, screws 1 g) and 18 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject X2 B sufficient for the Audio-Technica AT-VM95ML?

The cartridge (6.1 g) is lighter than the lower limit of 7 g. The arm cannot be balanced cleanly with it. Check the manufacturer’s specification before buying.

What is fitted to the Pro-Ject X2 B at the factory?

According to the manufacturer the Pro-Ject X2 B ships with a different cartridge (Ortofon Quintet Red (MC)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026