Compatibility · Oct 2026
Nagaoka MP-150 on the Pro-Ject X8 Evolution: does it fit?
Does the Nagaoka MP-150 fit the tonearm of the Pro-Ject X8 Evolution? With 8.5 g of effective arm mass and 6.5 g for the cartridge the calculation gives 12.1 Hz (range 10.9–13.3 Hz); verdict: borderline. Orientation only; check the manufacturer’s specifications; errors excepted.
Verdict: borderline
Borderline: at least one point is at the edge. Checks at the edge: Resonance.
- Resonance: 12.1 Hz (range 10.9–13.3 Hz)
- Moving mass: 16 g
- Compliance: 10.8 µm/mN at 10 Hz
- Cartridge: 6.5 g
With the X8 Pro-Ject supplies two counterweights (5 to 7.5 g and 7 to 10 g); the 6.5 g of the MP-150 fit the lighter one. The catch is the resonance: the stiff cartridge (6×10⁻⁶ cm/dyn at 100 Hz) reaches about 12.1 Hz on the 8.5 g arm, and the upper end of the range, 13.3 Hz, approaches the warning limit. According to our test page the MP-150 costs about €320 to 380; on paper there are better partners for the X8.
The calculation in detail
Whether arm and cartridge work together depends on mounting, resonance and counterweight. Each point is rated on its own, and the verdict follows the worst result.
-
Mountingfits
The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.
Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).
-
Resonanceborderline
The resonance of 12.1 Hz is above the target zone. The higher it rises, the closer it gets to audible bass; up to 14 Hz this counts as a warning, not as an exclusion.
Advisor output: fᵣ ≈ 12.1 Hz (range 10.9–13.3 Hz) by 159 / √(16 × 10.8); target 8–12 Hz, warning outside 7–14 Hz. Mass 8.5 g arm + 6.5 g cartridge + 1 g screws = 16 g; compliance 6 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 9–13.2 µm/mN at 10 Hz (rule of thumb, middle 10.8). Calculation note, not a measurement.
-
Counterweightfits
The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–10 g.
Advisor output: Cartridge 6.5 g is within the range 5–10 g (cartridge weight (Pro-Ject: two counterweights supplied, 5–7.5 g and 7–10 g)).
How the resonance comes about
- Moving mass: 8.5 g arm + 6.5 g cartridge + 1 g screws = 16 g.
- Compliance at 10 Hz: The compliance of 6×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 9 to 13.2 µm/mN; the calculation uses the middle (factor 1.8): 10.8 µm/mN.
- Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(16 × 10.8) = 159 / √172.8 ≈ 12.1 Hz.
- Range: Because the compliance is converted, the result is 10.9–13.3 Hz (worst and best case).
The input data
Tonearm: Pro-Ject 9cc Evolution (Pro-Ject X8 Evolution)
- Effective mass
- 8.5 g · manufacturer figure, source: project-audio.com
- Mounting
- fixed headshell with half-inch mount
- Counterweight
- 5–10 g · cartridge weight (Pro-Ject: two counterweights supplied, 5–7.5 g and 7–10 g)
Cartridge: Nagaoka MP-150
- Type
- MP high-output · Nude Elliptical 0.4×0.7 mil
- Weight
- 6.5 g
- Compliance
- 6×10⁻⁶ cm/dyn at 100 Hz
- Tracking force
- 15–20 mN · recommended 18 mN (1.8 g)
- Output voltage
- 4.5 mV
- Market price
- about €320–380 (prices without guarantee, Oct 2026)
In our data there is no fixed factory cartridge documented for the Pro-Ject X8 Evolution (manufacturer: available from the factory with or without an Ortofon Quintet Blue (MC)). The calculation applies to a cartridge of your own choice.
Next steps
- Check the highlighted points above (Resonance) in the manufacturer’s documents.
- If needed, ask a dealer or the manufacturer whether the combination is recommended in everyday use.
- If you are unsure, look for a cartridge that passes all three checks (see the alternatives below).
The Nagaoka MP-150 is a moving-magnet cartridge (4.5 mV) and works on a normal MM phono input. If the Pro-Ject X8 Evolution has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.
Alternatives
Our tip: On the X8 the Sumiko Moonstone (about €300–390) reaches 8.5 Hz with 6.6 g, clearly inside the target zone.
More cartridges on the Pro-Ject X8 Evolution
Also unproblematic on paper on the Pro-Ject X8 Evolution are these cartridges in a comparable price range (without guarantee):
- Audio-Technica AT-OC9XEN: calculated resonance 9.6 Hz, 7.6 g, about €280–370
- Sumiko Moonstone: calculated resonance 8.5 Hz, 6.6 g, about €300–390
- Ortofon 2M Bronze: calculated resonance 8.3 Hz, 7.2 g, about €350–420
- Nagaoka MP-200: calculated resonance 11 Hz, 6.5 g, about €400–480
The Nagaoka MP-150 on other turntables
If you would rather change the turntable: on these models the Nagaoka MP-150 passes all three checks:
- Pro-Ject T2 W: calculated resonance 11.7 Hz, arm 9.5 g
- SME Model 6: calculated resonance 11.7 Hz, arm 9.5 g
- Pro-Ject Signature 12: calculated resonance 9.1 Hz, arm 20.6 g
Method in brief
- Procedure
- Following the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
- Verdict rule
- One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
- Data
- Advisor data of 2 Oct 2026, page of 3 Oct 2026
- Limits
- No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.
Frequently asked questions
Can I run the Nagaoka MP-150 on the Pro-Ject X8 Evolution?
With reservations. The Nagaoka MP-150 on the Pro-Ject X8 Evolution is borderline; Resonance is at the edge of the target zone. Calculated resonance: 12.1 Hz (range 10.9–13.3 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.
What resonance frequency results for the Nagaoka MP-150 on the Pro-Ject X8 Evolution?
About 12.1 Hz (range 10.9–13.3 Hz). The calculation uses 159 / √(mass × compliance): 16 g moving mass (arm 8.5 g, cartridge 6.5 g, screws 1 g) and 10.8 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.
Is the counterweight of the Pro-Ject X8 Evolution sufficient for the Nagaoka MP-150?
The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–10 g.
What phono input does the Nagaoka MP-150 need?
The Nagaoka MP-150 is a moving-magnet cartridge (4.5 mV) and works on a normal MM phono input. If the Pro-Ject X8 Evolution has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.
How reliable is this calculation?
It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.
Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability
Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026