Compatibility · Oct 2026

Nagaoka MP-110 on the Pro-Ject Signature 12: does it fit?

Does the Nagaoka MP-110 fit the tonearm of the Pro-Ject Signature 12? With 20.6 g of effective arm mass and 6.5 g for the cartridge the calculation gives 9.1 Hz (range 8.1–10.2 Hz); verdict: fits. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: fits Resonance 9.1 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: fits

Fits according to our calculation. All three checks (mounting, resonance, counterweight) pass.

  • Resonance: 9.1 Hz (range 8.1–10.2 Hz)
  • Moving mass: 28.1 g
  • Compliance: 10.8 µm/mN at 10 Hz
  • Cartridge: 6.5 g

The stiff MP-110 (6.5 g, 6×10⁻⁶ cm/dyn at 100 Hz), which produces resonances that are too high on light arms (see Debut Carbon EVO), is in good hands on the heavy 12-inch arm of the Signature 12: about 9.1 Hz with a range of 8.1 to 10.2 Hz lies completely in the target zone, and the 6.5 g fit the counterweight without an auxiliary weight (4.5 to 8 g).

Resonance band: Nagaoka MP-110 on Pro-Ject Signature 12 Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 9.1 Hz, range 8.1 to 10.2 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 9.1 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

Whether arm and cartridge work together depends on mounting, resonance and counterweight. Each point is rated on its own, and the verdict follows the worst result.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Removable headshell with half-inch mount (manufacturer).

  • Resonancefits

    The calculated resonance of 9.1 Hz lies in the target zone. The rule-of-thumb range stays within the warning limits.

    Advisor output: fᵣ ≈ 9.1 Hz (range 8.1–10.2 Hz) by 159 / √(28.1 × 10.8); target 8–12 Hz, warning outside 7–14 Hz. Mass 20.6 (19.5–21.7) g arm + 6.5 g cartridge + 1 g screws = 28.1 g; compliance 6 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 9–13.2 µm/mN at 10 Hz (rule of thumb, middle 10.8). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 6.5 g lies within the range 4.5–8 g.

    Advisor output: Cartridge 6.5 g is within the range 4.5–8 g (cartridge weight (Pro-Ject: 4.5–8 g without auxiliary weight; 8–15 or 15–23 g with auxiliary weight)).

How the resonance comes about

  1. Moving mass: 20.6 g arm (range 19.5–21.7 g) + 6.5 g cartridge + 1 g screws = 28.1 g.
  2. Compliance at 10 Hz: The compliance of 6×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 9 to 13.2 µm/mN; the calculation uses the middle (factor 1.8): 10.8 µm/mN.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(28.1 × 10.8) = 159 / √303.5 ≈ 9.1 Hz.
  4. Range: Because the compliance is converted and the arm mass is given as a range, the result is 8.1–10.2 Hz (worst and best case).

The input data

Tonearm: Pro-Ject Signature 12 (12″, alloy headshell) (Pro-Ject Signature 12)

Effective mass
20.6 g (range 19.5–21.7 g) · manufacturer figure, source: project-audio.com
Mounting
removable headshell, half-inch mount
Counterweight
4.5–8 g, with auxiliary weight 8–23 g · cartridge weight (Pro-Ject: 4.5–8 g without auxiliary weight; 8–15 or 15–23 g with auxiliary weight)

Cartridge: Nagaoka MP-110

Type
MP high-output · elliptical bonded 0.4×0.7 mil
Weight
6.5 g
Compliance
6×10⁻⁶ cm/dyn at 100 Hz
Tracking force
15–20 mN · recommended 18 mN (1.8 g)
Output voltage
5 mV
Market price
about €130–160 (prices without guarantee, Oct 2026)

In our data there is no fixed factory cartridge documented for the Pro-Ject Signature 12. The calculation applies to a cartridge of your own choice.

Next steps

  • Set the tracking force as specified by the manufacturer (15–20 mN · recommended 18 mN (1.8 g)) and check it with a gauge.
  • Set the overhang with the alignment protractor, then the anti-skating.
  • Compare the manufacturer’s specifications for arm and cartridge before you order or mount.

The Nagaoka MP-110 is a moving-magnet cartridge (5 mV) and works on a normal MM phono input. If the Pro-Ject Signature 12 has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: From the same family, only higher up the range: the Nagaoka MP-150 (about €320–380) with 6.5 g and 9.1 Hz.

More cartridges on the Pro-Ject Signature 12

More cartridges that pass all three checks on the Pro-Ject Signature 12 and are close in price (without guarantee):

The Nagaoka MP-110 on other turntables

If you would rather change the turntable: on these models the Nagaoka MP-110 passes all three checks:

Method in brief

Procedure
Following the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Can I run the Nagaoka MP-110 on the Pro-Ject Signature 12?

Yes, according to our calculation the Nagaoka MP-110 fits the Pro-Ject Signature 12: mounting, resonance and counterweight pass. Calculated resonance: 9.1 Hz (range 8.1–10.2 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

What resonance frequency results for the Nagaoka MP-110 on the Pro-Ject Signature 12?

About 9.1 Hz (range 8.1–10.2 Hz). The calculation uses 159 / √(mass × compliance): 28.1 g moving mass (arm 20.6 g, cartridge 6.5 g, screws 1 g) and 10.8 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject Signature 12 sufficient for the Nagaoka MP-110?

The arm’s counterweight covers the cartridge: 6.5 g lies within the range 4.5–8 g.

What phono input does the Nagaoka MP-110 need?

The Nagaoka MP-110 is a moving-magnet cartridge (5 mV) and works on a normal MM phono input. If the Pro-Ject Signature 12 has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026