Compatibility · Oct 2026

Ortofon 2M Red on the Pro-Ject T2 W: does it fit?

Does the Ortofon 2M Red fit the tonearm of the Pro-Ject T2 W? With 9.5 g of effective arm mass and 7.2 g for the cartridge the calculation gives 8.5 Hz; verdict: fits. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: fits Resonance 8.5 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: fits

Fits according to our calculation. All three checks (mounting, resonance, counterweight) pass.

  • Resonance: 8.5 Hz
  • Moving mass: 17.7 g
  • Compliance: 20 µm/mN at 10 Hz
  • Cartridge: 7.2 g

Anyone swapping the T2 W’s factory cartridge (Sumiko Rainier) for a 2M Red gets a slightly heavier and more softly suspended cartridge. The resonance falls from 9.1 to 8.5 Hz but stays inside the target zone, and the 7.2 g fit the wide counterweight range (5 to 11.5 g). The 8.5 Hz figure comes without conversion because Ortofon specifies the compliance at 10 Hz.

Resonance band: Ortofon 2M Red on Pro-Ject T2 W Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 8.5 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 8.5 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz).

The calculation in detail

Whether arm and cartridge work together depends on mounting, resonance and counterweight. Each point is rated on its own, and the verdict follows the worst result.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonancefits

    The calculated resonance of 8.5 Hz lies in the target zone of 8–12 Hz.

    Advisor output: fᵣ ≈ 8.5 Hz by 159 / √(17.7 × 20); target 8–12 Hz, warning outside 7–14 Hz. Mass 9.5 g arm + 7.2 g cartridge + 1 g screws = 17.7 g; compliance 20 µm/mN (10 Hz, per data sheet). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 7.2 g lies within the range 5–11.5 g.

    Advisor output: Cartridge 7.2 g is within the range 5–11.5 g (cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)).

How the resonance comes about

  1. Moving mass: 9.5 g arm + 7.2 g cartridge + 1 g screws = 17.7 g.
  2. Compliance at 10 Hz: The compliance of 20 µm/mN is specified at 10 Hz and is used unchanged.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(17.7 × 20) = 159 / √354 ≈ 8.5 Hz.

The input data

Tonearm: Pro-Ject 9 aluminium (Pro-Ject T2 W)

Effective mass
9.5 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
5–11.5 g · cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)

Cartridge: Ortofon 2M Red

Type
MM · elliptical bonded (r/R 8/18 µm)
Weight
7.2 g
Compliance
20 µm/mN at 10 Hz
Tracking force
1.6–2.0 g (recommended 1.8 g)
Output voltage
5.5 mV
Market price
about €85–100 (prices without guarantee, Oct 2026)

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

Next steps

  • Set the tracking force as specified by the manufacturer (1.6–2.0 g (recommended 1.8 g)) and check it with a gauge.
  • Set the overhang with the alignment protractor, then the anti-skating.
  • Compare the manufacturer’s specifications for arm and cartridge before you order or mount.

The Ortofon 2M Red is a moving-magnet cartridge (5.5 mV) and works on a normal MM phono input. If the Pro-Ject T2 W has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: Slightly cheaper is the Goldring E2 (about €70–100): 6.9 g and 10.6 Hz on the T2 W.

More cartridges on the Pro-Ject T2 W

More cartridges that pass all three checks on the Pro-Ject T2 W and are close in price (without guarantee):

The Ortofon 2M Red on other turntables

If you would rather change the turntable: on these models the Ortofon 2M Red passes all three checks:

Method in brief

Procedure
Following the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Can I run the Ortofon 2M Red on the Pro-Ject T2 W?

Yes, according to our calculation the Ortofon 2M Red fits the Pro-Ject T2 W: mounting, resonance and counterweight pass. Calculated resonance: 8.5 Hz. Orientation only; check the manufacturer’s specifications; errors excepted.

What resonance frequency results for the Ortofon 2M Red on the Pro-Ject T2 W?

About 8.5 Hz. The calculation uses 159 / √(mass × compliance): 17.7 g moving mass (arm 9.5 g, cartridge 7.2 g, screws 1 g) and 20 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject T2 W sufficient for the Ortofon 2M Red?

The arm’s counterweight covers the cartridge: 7.2 g lies within the range 5–11.5 g.

What is fitted to the Pro-Ject T2 W at the factory?

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet. Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026