Compatibility · Oct 2026

Audio-Technica AT-VM95E on the Pro-Ject T2 W: does it fit?

We worked through the tonearm of the Pro-Ject T2 W (Pro-Ject 9 aluminium, 9.5 g effective mass) and the cartridge Audio-Technica AT-VM95E (6.1 g) with the calculation method of our Advisor. Result: fits, calculated resonance 11 Hz (range 9.9–12 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: fits Resonance 11 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: fits

Fits according to our calculation. All three checks (mounting, resonance, counterweight) pass.

  • Resonance: 11 Hz (range 9.9–12 Hz)
  • Moving mass: 16.6 g
  • Compliance: 12.6 µm/mN at 10 Hz
  • Cartridge: 6.1 g

At about 11 Hz the AT-VM95E on the T2 W sits in the upper part of the target zone, and the upper end of the rule-of-thumb range stops exactly at 12 Hz. That is one of the tight cases among the “fits” results on this page: a little less arm mass or a slightly stiffer cartridge would tip the calculation to “borderline”. According to our data the AT-VM95E costs only about €55 to 70.

Resonance band: Audio-Technica AT-VM95E on Pro-Ject T2 W Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 11 Hz, range 9.9 to 12 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 11 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

Three points decide whether a cartridge fits a tonearm: the mounting, the resonance of arm and cartridge, and the counterweight. The overall verdict is as strict as the weakest point.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonancefits

    The calculated resonance of 11 Hz lies in the target zone. The rule-of-thumb range stays within the warning limits.

    Advisor output: fᵣ ≈ 11 Hz (range 9.9–12 Hz) by 159 / √(16.6 × 12.6); target 8–12 Hz, warning outside 7–14 Hz. Mass 9.5 g arm + 6.1 g cartridge + 1 g screws = 16.6 g; compliance 7 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 10.5–15.4 µm/mN at 10 Hz (rule of thumb, middle 12.6). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 6.1 g lies within the range 5–11.5 g.

    Advisor output: Cartridge 6.1 g is within the range 5–11.5 g (cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)).

How the resonance comes about

  1. Moving mass: 9.5 g arm + 6.1 g cartridge + 1 g screws = 16.6 g.
  2. Compliance at 10 Hz: The compliance of 7×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 10.5 to 15.4 µm/mN; the calculation uses the middle (factor 1.8): 12.6 µm/mN.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(16.6 × 12.6) = 159 / √209.2 ≈ 11 Hz.
  4. Range: Because the compliance is converted, the result is 9.9–12 Hz (worst and best case).

The input data

Tonearm: Pro-Ject 9 aluminium (Pro-Ject T2 W)

Effective mass
9.5 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
5–11.5 g · cartridge weight (Pro-Ject: counterweight No. 105 for 5–11.5 g)

Cartridge: Audio-Technica AT-VM95E

Type
VM Dual-MM · elliptical bonded 0.3×0.7 mil
Weight
6.1 g
Compliance
7×10⁻⁶ cm/dyn at 100 Hz
Tracking force
1.8–2.2 g · recommended 2.0 g
Output voltage
4 mV
Market price
about €55–70 (prices without guarantee, Oct 2026)

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

What this means for you

  • Set the tracking force as specified by the manufacturer (1.8–2.2 g · recommended 2.0 g) and check it with a gauge.
  • Set the overhang with the alignment protractor, then the anti-skating.
  • Compare the manufacturer’s specifications for arm and cartridge before you order or mount.

The Audio-Technica AT-VM95E is a moving-magnet cartridge (4 mV) and works on a normal MM phono input. If the Pro-Ject T2 W has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: Lower in the target zone sits the Ortofon OM 5E (about €45–70) at 9 Hz; it weighs 5 g.

More cartridges on the Pro-Ject T2 W

If you would like to compare: these cartridges also pass all three checks on the Pro-Ject T2 W and cost roughly the same according to our test pages (prices without guarantee):

The Audio-Technica AT-VM95E on other turntables

On these turntables the Audio-Technica AT-VM95E passes all three checks according to the calculation:

Method in brief

Procedure
As in the Advisor: resonance fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Does the Audio-Technica AT-VM95E fit the Pro-Ject T2 W?

Yes, according to our calculation the Audio-Technica AT-VM95E fits the Pro-Ject T2 W: mounting, resonance and counterweight pass. Calculated resonance: 11 Hz (range 9.9–12 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

How high is the resonance of the Audio-Technica AT-VM95E and the Pro-Ject T2 W?

About 11 Hz (range 9.9–12 Hz). The calculation uses 159 / √(mass × compliance): 16.6 g moving mass (arm 9.5 g, cartridge 6.1 g, screws 1 g) and 12.6 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject T2 W sufficient for the Audio-Technica AT-VM95E?

The arm’s counterweight covers the cartridge: 6.1 g lies within the range 5–11.5 g.

What is fitted to the Pro-Ject T2 W at the factory?

According to the manufacturer the Pro-Ject T2 W ships with a different cartridge (Sumiko Rainier (MM)). The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026