Compatibility · Oct 2026

Nagaoka MP-110 on the Pro-Ject Debut Carbon EVO: does it fit?

Checked on paper: the tonearm of the Pro-Ject Debut Carbon EVO (Pro-Ject 8.6 Carbon (one-piece), 6 g effective mass) with the cartridge Nagaoka MP-110 (6.5 g). The Advisor arrives at 13.2 Hz (range 11.9–14.4 Hz); the verdict is “borderline”. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: borderline Resonance 13.2 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: borderline

Borderline: at least one point is at the edge. Checks at the edge: Resonance.

  • Resonance: 13.2 Hz (range 11.9–14.4 Hz)
  • Moving mass: 13.5 g
  • Compliance: 10.8 µm/mN at 10 Hz
  • Cartridge: 6.5 g

A stiff cartridge on a very light arm: the Nagaoka MP-110 (6.5 g, 6×10⁻⁶ cm/dyn at 100 Hz) reaches about 13.2 Hz on the 6 g arm of the EVO, and the upper end of the range, 14.4 Hz, crosses the warning limit. Weight and mounting are fine. On the Technics SL-1200GR2 with 8.5 g arm mass the same cartridge sits at 12.1 Hz: the arm has a say, not only the cartridge.

Resonance band: Nagaoka MP-110 on Pro-Ject Debut Carbon EVO Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 13.2 Hz, range 11.9 to 14.4 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 13.2 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz). The grey bar shows the rule-of-thumb range.

The calculation in detail

The check runs in three steps: does the cartridge physically fit the arm, does the resonance of arm and cartridge lie in the target zone, and can the counterweight balance the cartridge weight? The weakest point decides the overall verdict.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonanceborderline

    The resonance of 13.2 Hz is above the target zone. The higher it rises, the closer it gets to audible bass; up to 14 Hz this counts as a warning, not as an exclusion.

    Advisor output: fᵣ ≈ 13.2 Hz (range 11.9–14.4 Hz) by 159 / √(13.5 × 10.8); target 8–12 Hz, warning outside 7–14 Hz. Mass 6 g arm + 6.5 g cartridge + 1 g screws = 13.5 g; compliance 6 ·10⁻⁶ cm/dyn at 100 Hz × 1.5–2.2 ≈ 9–13.2 µm/mN at 10 Hz (rule of thumb, middle 10.8). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–8.5 g.

    Advisor output: Cartridge 6.5 g is within the range 5–8.5 g (cartridge weight (Pro-Ject: supplied counterweight for 5–8.5 g)).

How the resonance comes about

  1. Moving mass: 6 g arm + 6.5 g cartridge + 1 g screws = 13.5 g.
  2. Compliance at 10 Hz: The compliance of 6×10⁻⁶ cm/dyn is specified at 100 Hz. For 10 Hz the rule of thumb is 1.5 to 2.2 times that, i.e. 9 to 13.2 µm/mN; the calculation uses the middle (factor 1.8): 10.8 µm/mN.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(13.5 × 10.8) = 159 / √145.8 ≈ 13.2 Hz.
  4. Range: Because the compliance is converted, the result is 11.9–14.4 Hz (worst and best case).

The input data

Tonearm: Pro-Ject 8.6 Carbon (one-piece) (Pro-Ject Debut Carbon EVO)

Effective mass
6 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
5–8.5 g · cartridge weight (Pro-Ject: supplied counterweight for 5–8.5 g)

Cartridge: Nagaoka MP-110

Type
MP high-output · elliptical bonded 0.4×0.7 mil
Weight
6.5 g
Compliance
6×10⁻⁶ cm/dyn at 100 Hz
Tracking force
15–20 mN · recommended 18 mN (1.8 g)
Output voltage
5 mV
Market price
about €130–160 (prices without guarantee, Oct 2026)

The Pro-Ject Debut Carbon EVO ships with the Ortofon 2M Red. The calculation here therefore describes a swap, i.e. an upgrade scenario.

What you can do with this

  • Check the highlighted points above (Resonance) in the manufacturer’s documents.
  • If needed, ask a dealer or the manufacturer whether the combination is recommended in everyday use.
  • If you are unsure, look for a cartridge that passes all three checks (see the alternatives below).

The Nagaoka MP-110 is a moving-magnet cartridge (5 mV) and works on a normal MM phono input. If the Pro-Ject Debut Carbon EVO has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: The Ortofon 2M Blue (about €160–200) is suspended more softly and lies at 9.4 Hz on the EVO, inside the target zone; the weight is 7.2 g.

More cartridges on the Pro-Ject Debut Carbon EVO

On the Pro-Ject Debut Carbon EVO these cartridges also pass all three checks, at a similar price (without guarantee):

The Nagaoka MP-110 on other turntables

On paper the Nagaoka MP-110 can also be run on these turntables without objection:

Method in brief

Procedure
Same formula as in the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Is the Nagaoka MP-110 a good choice for the Pro-Ject Debut Carbon EVO?

With reservations. The Nagaoka MP-110 on the Pro-Ject Debut Carbon EVO is borderline; Resonance is at the edge of the target zone. Calculated resonance: 13.2 Hz (range 11.9–14.4 Hz). Orientation only; check the manufacturer’s specifications; errors excepted.

At what frequency do the Nagaoka MP-110 and the arm of the Pro-Ject Debut Carbon EVO resonate?

About 13.2 Hz (range 11.9–14.4 Hz). The calculation uses 159 / √(mass × compliance): 13.5 g moving mass (arm 6 g, cartridge 6.5 g, screws 1 g) and 10.8 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject Debut Carbon EVO sufficient for the Nagaoka MP-110?

The arm’s counterweight covers the cartridge: 6.5 g lies within the range 5–8.5 g.

What is fitted to the Pro-Ject Debut Carbon EVO at the factory?

The Pro-Ject Debut Carbon EVO ships with the Ortofon 2M Red. The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet, converted with a rule of thumb (factor 1.5–2.2 for 100 Hz values). Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026