Compatibility · Oct 2026

Ortofon OM 10 on the Pro-Ject Debut Carbon EVO: does it fit?

Does the Ortofon OM 10 fit the tonearm of the Pro-Ject Debut Carbon EVO? With 6 g of effective arm mass and 5 g for the cartridge the calculation gives 9.2 Hz; verdict: fits. Orientation only; check the manufacturer’s specifications; errors excepted.

Verdict: fits Resonance 9.2 Hz Orientation · errors excepted Updated 3 Oct 2026

Verdict: fits

Fits according to our calculation. All three checks (mounting, resonance, counterweight) pass.

  • Resonance: 9.2 Hz
  • Moving mass: 12 g
  • Compliance: 25 µm/mN at 10 Hz
  • Cartridge: 5 g

The OM 10 weighs exactly 5 g and thus hits the lower limit of the supplied counterweight (5 to 8.5 g) on the dot; the calculation still counts that as passed. The resonance is 9.2 Hz and comes without any conversion (25 µm/mN at 10 Hz). Anyone running the OM 10 on the EVO is therefore balancing at the edge of what is possible, but inside the permitted range.

Resonance band: Ortofon OM 10 on Pro-Ject Debut Carbon EVO Scale 5 to 15 Hz. Target zone 8 to 12 Hz, warning outside 7 to 14 Hz. Calculated resonance 9.2 Hz. 5 6 7 8 9 10 11 12 13 14 15 Resonance frequency in Hz Target 8–12 Warning from 7 to 14 9.2 Hz
Calculated resonance compared with the target zone (green: 8–12 Hz) and the warning zone (yellow: 7–14 Hz).

The calculation in detail

Whether arm and cartridge work together depends on mounting, resonance and counterweight. Each point is rated on its own, and the verdict follows the worst result.

  • Mountingfits

    The cartridge has the usual half-inch mounting (two screws, hole spacing ½ inch), and the arm’s headshell is designed for it.

    Advisor output: Fixed headshell with half-inch mounting holes (manufacturer: cartridges with a half-inch mount fit).

  • Resonancefits

    The calculated resonance of 9.2 Hz lies in the target zone of 8–12 Hz.

    Advisor output: fᵣ ≈ 9.2 Hz by 159 / √(12 × 25); target 8–12 Hz, warning outside 7–14 Hz. Mass 6 g arm + 5 g cartridge + 1 g screws = 12 g; compliance 25 µm/mN (10 Hz, per data sheet). Calculation note, not a measurement.

  • Counterweightfits

    The arm’s counterweight covers the cartridge: 5 g lies within the range 5–8.5 g.

    Advisor output: Cartridge 5 g is within the range 5–8.5 g (cartridge weight (Pro-Ject: supplied counterweight for 5–8.5 g)).

How the resonance comes about

  1. Moving mass: 6 g arm + 5 g cartridge + 1 g screws = 12 g.
  2. Compliance at 10 Hz: The compliance of 25 µm/mN is specified at 10 Hz and is used unchanged.
  3. Formula: fᵣ = 159 / √(mass × compliance) = 159 / √(12 × 25) = 159 / √300 ≈ 9.2 Hz.

The input data

Tonearm: Pro-Ject 8.6 Carbon (one-piece) (Pro-Ject Debut Carbon EVO)

Effective mass
6 g · manufacturer figure, source: project-audio.com
Mounting
fixed headshell with half-inch mount
Counterweight
5–8.5 g · cartridge weight (Pro-Ject: supplied counterweight for 5–8.5 g)

Cartridge: Ortofon OM 10

Type
MM · elliptical bonded r/R 8/18 µm
Weight
5 g
Compliance
25 µm/mN at 10 Hz
Tracking force
1.25–1.75 g · recommended 1.5 g
Output voltage
4 mV
Market price
about €55–85 (prices without guarantee, Oct 2026)

The Pro-Ject Debut Carbon EVO ships with the Ortofon 2M Red. The calculation here therefore describes a swap, i.e. an upgrade scenario.

Next steps

  • Set the tracking force as specified by the manufacturer (1.25–1.75 g · recommended 1.5 g) and check it with a gauge.
  • Set the overhang with the alignment protractor, then the anti-skating.
  • Compare the manufacturer’s specifications for arm and cartridge before you order or mount.

The Ortofon OM 10 is a moving-magnet cartridge (4 mV) and works on a normal MM phono input. If the Pro-Ject Debut Carbon EVO has no built-in phono stage or the amplifier has no phono input, the top list of phono preamps helps.

Alternatives

Our tip: At 6.5 g the Sumiko Rainier (about €140–170) sits in the middle of the counterweight range instead of at its edge; the resonance is 10.2 Hz.

More cartridges on the Pro-Ject Debut Carbon EVO

More cartridges that pass all three checks on the Pro-Ject Debut Carbon EVO and are close in price (without guarantee):

  • Ortofon OM 5E: calculated resonance 10.3 Hz, 5 g, about €45–70
  • Ortofon 2M Red: calculated resonance 9.4 Hz, 7.2 g, about €85–100
  • Goldring E2: calculated resonance 11.8 Hz, 6.9 g, about €70–100
  • Sumiko Rainier: calculated resonance 10.2 Hz, 6.5 g, about €140–170

The Ortofon OM 10 on other turntables

If you would rather change the turntable: on these models the Ortofon OM 10 passes all three checks:

Method in brief

Procedure
Following the Advisor: fᵣ = 159 / √(mass × compliance), target 8–12 Hz, warning outside 7–14 Hz. Mass = arm mass + cartridge weight + 1 g screws. 100 Hz values are converted with 1.5–2.2.
Verdict rule
One point outside: “does not fit”. Mounting or resonance not verifiable: “not verifiable”. One point at the edge: “borderline”. Otherwise “fits”.
Data
Advisor data of 2 Oct 2026, page of 3 Oct 2026
Limits
No measurement, no guarantee. Orientation only; check the manufacturer’s specifications; errors excepted.

Frequently asked questions

Can I run the Ortofon OM 10 on the Pro-Ject Debut Carbon EVO?

Yes, according to our calculation the Ortofon OM 10 fits the Pro-Ject Debut Carbon EVO: mounting, resonance and counterweight pass. Calculated resonance: 9.2 Hz. Orientation only; check the manufacturer’s specifications; errors excepted.

What resonance frequency results for the Ortofon OM 10 on the Pro-Ject Debut Carbon EVO?

About 9.2 Hz. The calculation uses 159 / √(mass × compliance): 12 g moving mass (arm 6 g, cartridge 5 g, screws 1 g) and 25 µm/mN at 10 Hz. The target zone is 8–12 Hz; a warning applies outside 7–14 Hz.

Is the counterweight of the Pro-Ject Debut Carbon EVO sufficient for the Ortofon OM 10?

The arm’s counterweight covers the cartridge: 5 g lies within the range 5–8.5 g.

What is fitted to the Pro-Ject Debut Carbon EVO at the factory?

The Pro-Ject Debut Carbon EVO ships with the Ortofon 2M Red. The calculation here therefore describes a swap, i.e. an upgrade scenario.

How reliable is this calculation?

It is an orientation, not a measurement. The arm mass comes from a manufacturer figure, the compliance from the manufacturer’s data sheet. Data as of 2 Oct 2026. Check the manufacturer’s specifications; errors excepted.

Orientation only; check the manufacturer’s specifications; errors excepted. Calculation by the AI Vinyl BotPro based on manufacturer data, without listening test and without measurement, not purchase advice in the legal sense. Notices & liability

Updated 3 Oct 2026 · Advisor data 2 Oct 2026 · Prices without guarantee, Oct 2026